Cristiano Maker

  There are several ways of storing rocks and minerals specimens. Some prefer to have them visible, other prefer to have them secured in boxes. Personally, I prefer to have them stored in a box, so they don't get dirty with dust, so I decided to build a simple wooden box. It is a simple rectangular box with small boxes inside like drawers that are pulled from top. Dimensions of the main box are 40cm length x 20cm wide x 25cm height. There is space for about 4 drawers inside. I have organized the smaller specimens into paper boxes, although the larger specimens are loose. You can see a small video of how it works to open and pull the inner drawers:  https://www.youtube.com/shorts/LhDBVJ7s5Vk I have used this style of box to store minerals but I can be used for any other kind of collectible.

 I have an old kerosene pressure lamp, a Ditmar Maxim 520, but when I bought it, it come with some little cracks in the tank, so the first time I tried to turn it on, I noticed the kesorene leaking at the bottom. Searching in some forums for a possible solution, I have found a simple one: filling the cracks with tin solder. Here is a step by step if you also need to repair your pressure lamps: 1 - Identify all the cracks. 2 - With a dremel, open the cracks exposing the internal metal (make sure your tank is empty and dry of kerosene). 3 - With a torch and tin solder (the one used in electronics), fill the exposed metal crack with it. 4 - Test the pressure before adding kerosene. 5 - If the pressure keeps ok, you are ready to use your lamp again! Here is a small Youtube short video of the process: https://www.youtube.com/shorts/0442OXCgXjc  This is the final repaired tank:

 One of my hobbies is to build electronics projects, like metal detectors for treasure hunting. Usually electronics boards are hold inside a plastic or metal box. There both in the market, but usually they are not so cheap. One solution I thought about, was to build my own boxes using aluminum sheet as it is a soft metal. Although aluminum is soft, for the thickness I want to use (2mm) it is not so easy to bend it by hand, so I searched a bit how to make a tool to bend the metal with the less effort possible and with good results at the end, I came up with this, using only 3 pieces of wood, 2 screws with bolts and 2 hinges: This is known as a sheet metal brake, mine is simple, made of pine wood but I recommend you to use harder woods, specially if you need to bend metals harder tha aluminum. I think you can replicate one easily just by looking at the pictures above, so I'm not provinding any measurements but if you need, please write a comment below. For different sizes or formats ...

 As I work almost all day sitting down, there comes a time in the day when I get fed up of staying in that position for so long. So, I decided to make a simple and small desk that I can put on top of my main table and this is the result: This way I can simply add or remove the small table at any time I want to work standing up. Obviously there are in the market beautiful and comfortable standing desks, but at least here in Brazil, they are quite expensive so I decided to make mine with a few pieces of wood and 4 screws!